DK25 Power Pull Frame Machine

Kuhn Manufacturing on Facebook 767-6662
Kuhn Manufacturing
Auto body repair equipment since 1967
DK25 Power Pull Frame Machine

DK25 Power Pull Frame Machine

The DK25 Power Pull is built to handle the heavy hits. Designed with the same proven features as the DK300 Power Pull, the DK25 is larger and stronger in every way! Even with its size it is easy to use.  The four 6" Spring Loaded Swivel Casters transport and position the DK25 and then collapse during the pull. The DK25-14 Winch and Strap raises & lowers the 5/8" pull chain and floating pulley without strain.

Kuhn Mfg. manufactures the only power post on the market that can push as well as pull. Pushing a frame rail in a tight limited area increases the overall performance of the DK25 Power Pull. All pins are manufactured from 4140 Alloy Steel then heat treated for strength and longevity. Continuous pulling by using the Locking Dog (recycling lock) on either half or full links of chain eliminates restarting the pull when the ram is fully extended.

The heavy wall tube construction and crush tubes (bushings) strengthen & support pin (shaft) holes to eliminate elongation at all pressure points.

Portable, easy to use the DK25 Power Pull will meet or exceed all pulling requirements for heavy truck, bus and light rail chassis repair.

Optionally, use the DK38 Pulley Kit Accessory to double the tonnage of your frame pulls.

DK264A Pulley Kit Doubles Pull Tonnage

DK25 Frame Machine ComponentsDK25 Frame Machine Instructions

DK25 Power Pull Frame Machine Features & Accessories

D52 Floating Pulley

D52 Floating Pulley

The D52 Floating Pulley is raised and lowered by using the DK25-14 Winch/Strap Assembly.  The anchor chain tail with 5/8" GR80 Hook eliminates twisting of the yoke when positioned between floor anchors. More vertical post holes allow greater selection of pulls.

6 Inch Frame Machine Pulley

Wide Bodied, 6" Pulley

Kuhn 6’ pulley with wide-bodied cast chain grove supports 5/8” chain around the half circle without bending links during the pull. Smaller pulleys do not support chain links as well.

DK25 Lever Arm

DK25 Lever Arm

Kuhn fully suspended ram allows free travel through the lever arc without putting stress on the ram shaft seals.

D50 Locking Dog

D50 Locking Dog

The heavily supported D50 Locking Dog allows continuous pulling after the pull ram is fully extended. The D50 will engage a full or half link of chain. Pull tension is maintained during ram release, the D50 Locking Dog automatically disengages the chain when the pull is resumed.

DK25 Power Pull Winch/Strap

DK25-14 Winch/Strap

The DK25-14 Winch/Strap raises and lowers the Floating Pulley/Pull Chain and DK25-14 Push Yoke without any lifting.

DK25 Push Yoke Assembly in use for Heavy Truck Collision Repair

DK25-21 Push Yoke Assembly

Being raised and supported by the DK25-14 Winch Assembly (shown with DK25-14, DK25C and 6" 25 Ton Ram).

DK25 Push Yoke Assembly

DK25-21 Push Yoke Assembly

DK38 Power Pulley Kit

DK38 Power Pully Kit

Whether using the frame machine for a low or standard pull, the DK38 doubles the puller tonnage.

DK25 Frame Machine ComponentsDK25 Frame Machine Instructions

Site Terms/Agreement • TM Trademark ® Registered Trademarks ©2014 Kuhn Mfg. Co., Inc. • All Rights Reserved.